Guide

Why your Seestar image looks green, and how to fix it

You open a Seestar FITS file and the picture has a green tint over the whole frame. Nothing is wrong with your telescope or your capture. A stack that nobody has colour balanced looks like this, and it takes a few minutes to fix.

Why it is green

  • The sensor has more green pixels. A colour sensor puts a red, green or blue filter over each pixel, and green gets twice as many as red or blue. Until the three colours are balanced against each other, green is the strongest.
  • The sky has a colour too. Streetlights and the moon tint the background, and the tint depends on the lamps near you. It sits in the background of every frame, and it is not always green.
  • The stretch makes it easy to see. A linear stack is almost black. When you stretch it, you lift the faint signal, and a small colour imbalance in the background lifts with it. A tint you could not see in the linear data is obvious afterwards.

The Seestar app’s JPG usually does not show this, because the app balances the colour of the image for you. The FITS file is the data before that, so a cast can still be in it.

How to fix it

The order matters. Do the first step first.

  1. Remove the background gradient. A gradient that is strongest in one corner and tinted by the lamps below it looks like a colour cast. Take it out before you judge the colour. How to remove a light pollution gradient shows how.
  2. Calibrate the colour on the stars. In Siril, plate solve the image, then run photometric colour calibration. It compares the colour of your stars with a catalogue and sets the balance from them. The Seestar writes the sky coordinates into the FITS header, so the plate solve is usually one click. The same tool lets you pick an area of empty sky to be the neutral background.
  3. Remove what is left with “Remove Green Noise”. This Siril tool (also called SCNR) pulls green back toward the average of red and blue. Start with the default and a moderate amount. Look at the result after each try.
  4. Check on a stretched copy. Stretch with the three colours linked, so the stretch does not move them apart. Look at the empty sky: it should be a neutral dark grey, not tinted. Look at the stars: a field of stars should be white, yellow, orange and a little blue, not all one colour.

Do not remove all of the green

Some objects are really that colour. The Dumbbell Nebula, M27, is teal-green in the finished image on its gallery page, with a red rim. That is the light of doubly ionised oxygen and hydrogen. It is not a cast. If you use Remove Green Noise at full strength, a teal nebula can shift toward blue or grey.

If you shot through the Seestar’s dual-band filter, expect colours that differ from a normal colour photo. The filter lets through only a few narrow colours of light, and the nebulae show them.

What Stelora does about it

I wrote Stelora’s pipeline to do the balance for you. It measures the median colour of the stars in your frame above the local sky, then sets one gain per colour so the stars come out neutral, and applies those gains in full. If the frame has too few stars to measure, or the file was already stretched, it falls back to a standard green-removal step and does not guess.

A star-based balance can misread a frame with few or unusual stars. The star-colour step that comes after the stretch is capped, so that an automatic correction that misreads a frame cannot do much harm. How it works lists every stage.

More guides

Upload your FITS file Open a finished sample