Guide

How to combine Seestar images from several nights

A faint galaxy or nebula needs hours of light. A Seestar gets one or two hours on a good night, and then the target sets or the clouds come. Shoot the same target on more nights and join them, and the noise goes down, closer to what one long night would give.

What you need

  • Two to five nights on the same target, with the same telescope and the same filter.
  • From each night, the stacked file (Stacked_….fit or DSO_Stacked_….fit on a Seestar) or all of the raw subs.
  • Frames that overlap. Keep the target in the same place in the frame each night. A small shift or a turn of the field is fine; a different part of the sky is not.

Where your Seestar saves its FITS files shows how to copy them off the telescope.

Way 1: stack all of the subs in Siril

If you kept the raw subs (Save Each Frame), put the subs of every night in one folder and stack them together. The steps are in How to stack Seestar raw subs. This gives the best result, because the rejection step sees every frame. It also takes the most disk space and the most time.

Way 2: join the stacked files

If you have only the stacked file from each night, register the stacks (line up their stars) and average them. Give a cleaner night more weight than a hazy one. A plain average lets one bad night pull the whole image down.

On Stelora

  1. On the upload page, pick the stacked files from all of the nights together, two to five of them. Stelora asks if you want to combine them, and the button shows the cost.
  2. Stelora checks that they come from one telescope, at one size, with one filter, that they are not stretched yet, that no file is there twice, and that the nights overlap. A set that does not fit is refused before the upload, or its credits come back if the check fails later.
  3. It lines up the stars of each night on one reference, measures the noise of each night, and gives a cleaner night more weight. Then it crops to the part of the sky that every night covers and finishes the image as usual.
  4. The result page shows how much each night counts.

This works with the stacked files. Raw subs from several nights are not combined night by night: for them, use Way 1 in Siril.

The Seestar is what this is tuned on. Dwarf 3 stacked files are accepted too, but I have tested few of them.

A set is priced as one job, whatever the number of files, and you see the cost before anything is uploaded. If the combine fails, the credits come back by themselves.

Things to watch for

  • Different framing. Each night is cropped to the shared area, so a night that is far off-centre makes the image smaller.
  • A very hazy night. It gets a small weight, but it also adds little. Leave it out if it looks much worse than the rest.
  • A seam or an edge. This is new. If your result shows a line, a double star or a colour step, send me the files through the contact page. That is how it gets better.

More guides

Upload your FITS files Open a finished sample